Page 6 Model 205ce and 205Mce Operation Manual
PARTS
REPLACEMENT & OPTIONAL PARTS - are
major assemblies identified by a Balmac Model
Number. Most of these parts are field
replaceable and do not affect the calibration of
the instrument. Replacement Parts are also
listed on Balmac’s published Price List.
Model # Part Description
205 ce Meter (English)
205M ce Meter (Metric)
601 Accelerometer Vibration Pickup
051-5' Coiled Pickup Cable
2-pin female socket to
BNC connector
052 Magnetic Base Clamp (Mount)
with 1/4-28 Thread Stud
032-A Carrying Case
Manual and Calibration
Certificate (NIST Traceable)
BATTERY
The Balmac Model 205ce Vibration Meters come
equipped with 4 Size AA 1.5 Volt standard
alkaline batteries. Alkaline batteries are
recommended for maximum operation time.
LOW BATTERY - a low battery symbol “Lo-Bat”
or “¹”, will display (with instrument power “ON”)
when the batteries needs replacement.
REPLACING BATTERIES - (procedure)
1. Turn the 205 ce “OFF”.
2. Remove two #4-32 Phillips-head screws
from back battery cover. Remove cover.
3. Locate battery holder and carefully remove
old batteries.
4. Insert new batteries as indicated by outlines
in bottom of battery compartment. Replace
cover and tighten screws.
DISPOSAL
This product complies with the WEEE Directive
(2012/19/EU) marking requirements. The affixed
label indicates that you must not discard this
electrical/electronic product in domestic
household waste. Product Category: with
reference to the equipment types in the WEEE
Directive Annex I, this product is classed as
category 9 “Monitoring and Control
Instrumentation” product. Do not dispose of this
product as unsorted municipal waste. You can
hand over your meter at your nearest community
E-waste collection point or return the meter to
Balmac Inc.
To Next Page
Loading...