24 25
Technical data (for power indications please see product overview)
Mechanical and EN 50564
electrical safety EN 50581
EN 55014-1
EN 55014-2
EN 60335-1
EN 60335-2-14
EN 61000-3-2
EN 61000-3-3
EN 62233
Directives and standards 2014/35/EU LVD
2014/30/EU EMC
2011/65/EU RoHS
2009/125/EC Freamwork Directive
10/2011/EU PIM
94/62/EC Packing
2012/19/EU WEEE
1935/2004/EU FMC
Insulation Double insulation
Switch Safety switch with pulse contact
Intermittent operation max. 5 minutes at a time
Materials All parts are made from rust-free, odourless and tasteless
materials that are resistant to corrosive foodstuffs.
Test marks
www.tuev-sued.de/ps-zert.
Food contact We herewith certify that this product and its attachments
materials and accessories conform to the European Commission
Regulation No. 10/2011 on food contact materials.
It complies to all relevant statutory limits.
Disposal This product conforms to the European Directive 2012/19/EC
on waste electrical and electronic equipment – WEEE.
This Directive governs the disposal and recycling of such
equipment within the EU. For disposal instructions, please
contact your dealer or local authorities.
Manufacturer ESGE AG, Hauptstrasse 21, CH-9517 Mettlen/Schweiz
Made in Switzerland
All information in this document is subject to change without
prior notice. The above information might vary from country
to country.
www.bamix.com
Cleaning and care
(
Always disconnect the device from the mains supply)
The bamix
®
is very easy to clean. Remove the attachment and wash
it separately. To clean the attachment, rinse the dirty parts under
running water (do not switch on the appliance).
The easiest way to clean off bits of food which have stuck to the
bamix
®
is to hold it in a jug with hot water and switch it on.
Take care that the switch of the bamix
®
does not come into contact
with the water.
Important: Clean the appliance as soon as you have finished
working, to prevent the drive shaft or the attachment getting
clogged. If not in use, always remove the attachments from
the appliance.
To keep the bamix
®
running smoothly for longer, lubricate it every few
months with vegetable oil.
Hold the bamix
®
with the cutter guard facing up, lubricate the drive
shaft with 2-3 drops of oil and then run the appliance for approx.
30 seconds. Then clean the shaft with hot water.
What to do...
If the drive shaft of the appliance fails to rotate?
If the bamix
®
is not used for a prolonged period of time, the drive
shaft might become stuck, or the attachment might slip from the
shaft stub, as the parts are clogged up by minute food residue.
Place the attachment for 5-10 minutes in a jug of hot water.
Then switch on the appliance. Normally, all parts should now work
perfectly again. If not, try to free the shaft carefully with pliers.
Assembling SwissLine stand
1. Insert front panel into the base
2. Slide cable holder into place
3. Mount flap for the storage of the attachments
The appliance and the cutter guard are not suitab-
le for cleaning in the dishwasher. Corrosion (black
staining) may occur on the protective hood if it is
exposed to water for a longer time.
To Next Page
Loading...
