To Next Page
C
Connie SnyderAug 15, 2025
What to do if my BANDELIN Sonopuls HD 4050 device cannot be switched on?
- BBenjamin Adams Jr.Aug 15, 2025
If your BANDELIN Laboratory Equipment device isn't switching on and the display is blank, start by ensuring the plug connection is firmly in place. Inspect the mains cable for any damage, and if needed, replace it. Also, check the device fuses located in the cold device socket on the rear side of the generator and replace them if they are tripped. Finally, replace the main fuse if it is faulty. These issues may arise from no power, a loose or faulty mains cable, a tripped device fuse, or a faulty main fuse.
General
