To Next PageTo Next Page
Need help?Do you have a question about the Bandit INTIMIDATOR 15XPC and is the answer not in the manual?
Illustrates typical locations for serial and work order numbers on the chipper.
Explains the purpose of the manual and safety signal words.
Covers safe operation, PPE, and site preparation.
Details dangers like discharge, infeed hopper, and moving parts.
Addresses hydraulic leaks, battery safety, and knife handling.
Provides key physical dimensions and weight of the chipper.
Explains how to care for decals and their importance.
Explains various safety symbols and their meanings for safe operation.
Identifies key parts of the chipper from different perspectives.
Locates and lists the machine's controls and major components.
Details how to use specific controls like feedwheels and yoke lift.
Explains engine controls, hood disable, and air vents.
Outlines safe operation of the winch and its related functions.
Covers procedures for preparing, starting, and stopping the machine.
Details approximate settings for the digital autofeed system.
Lists essential steps for safely preparing the machine for transport.
Lists maintenance checks and their required frequency (daily to yearly).
Provides a chart with torque values for critical bolts and hardware.
Details essential daily checks, cleaning, and lubrication for safe operation.
Addresses common problems like poor chip quality and feed issues.
Covers knife sharpening, anvil adjustment, and related hardware.
Explains how to check and adjust belt tension for optimal performance.
Guides on servicing and changing feedwheel and chipper bearings.
Details how to adjust the Easy Climb Feed System spring tension.
Specifies recommended hydraulic fluid types and properties for the system.
Details relief pressures, flows, and general system maintenance advice.
Provides solutions for common hydraulic system problems and performance issues.
Details information needed for ordering replacement parts and general notices.
Lists parts for the infeed hopper assembly with diagrams.
Lists parts for the yoke assembly with diagrams.
Lists parts for the drum assembly with diagrams.
Lists parts for chipper knives and associated hardware.
Lists parts related to the anvil and its hardware.
Lists parts for the height adjustable hand crank swivel discharge.
Lists parts for the hydraulic and fuel tank systems.
Provides a table to log service dates, descriptions, and amounts.
Introduces the control panel, main display, and basic functions.
Explains navigation of the mode page for Fuel Saver and Bypass functions.
Details the meaning of various input and output signals for system monitoring.
Describes joystick operations and switch inputs for feed and winch.
Explains operating the machine in radio mode and its associated functions.
Details the function of Stop Cable, Feed Stop, and Winch On/Off switches.
Covers accessing setup menus and adjusting parameters like FuelSave Time.
Covers viewing engine data and DPF options for T4 engines.
Covers interpreting diagnostic codes and warning/stop indicators.
Explains managing service reminders and accessing factory settings.
Explains access to factory settings and configuration options.
General| Brand | Bandit |
|---|---|
| Model | INTIMIDATOR 15XPC |
| Category | Construction Equipment |
| Language | English |
