To Next PageTo Next Page
Need help?Do you have a question about the Bandit 200UC and is the answer not in the manual?
Illustrates typical locations for serial and work order numbers on the machine.
Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE.
General instructions relative to safe work practices and proper safety procedures.
Lists the length, width, height, weight, and capacities of the machine.
Labels the Radiator Side, Drive Side, Discharge End, and Infeed Hopper End.
Details the correct operation of the feedwheel control bar.
Explains how to adjust the tension for the control bar pivot and last chance cable.
Describes how the feedwheel control bar operates the feedwheels.
Safety instructions for opening or closing the feedwheel trap door.
Shuts down engine if hood pin is not properly in place.
Prevents hood pin removal if chipper disc is turning.
Instructions for starting the engine using the ignition switch and preheat.
Explains choke operation and throttle adjustment for engine speed.
Steps for preparing the work site and setting up the machine.
Steps to follow for safely starting the engine and machine.
Illustrates the correct feeding path and procedure for limbs and logs.
Step-by-step guide for safely shutting down the machine.
Procedures for engaging, disengaging, and operating the clutchless drive.
Explains the purpose and safe operation of the hydraulic bump bar.
Steps to complete before transporting the machine.
Daily, weekly, monthly, and yearly maintenance tasks.
Torque values for essential bolts and hardware.
Detailed explanations for daily, weekly, monthly, and yearly maintenance checks.
Detailed steps for safely unplugging a jammed chipper.
Procedures for installing and removing J.B. couplers and feedwheel motors.
Guidance on selecting and using appropriate hydraulic fluids.
Typical relief pressure and flow settings for the hydraulic system.
Wiring diagram for the standard 6-prong plug and 6-wire main cable.
Information needed for ordering chipper replacement parts.
Diagrams showing general locations of various decals on the machine.
A log to record dates, descriptions, and amounts for service performed.
General| Brand | Bandit |
|---|---|
| Model | 200UC |
| Category | Construction Equipment |
| Language | English |
