Bandit 200UC - Machine Operation; Feeding Diagram and Procedure

Bandit19
MODEL 200 UC OPERATION
MACHINE OPERATION
Butt end of
brush  rst
Release limb or
log into chipper
Turn away from the
infeed hopper and keep
moving after releasing the
limb or log.
Travel
Path
Travel
Path
Figure 1
1.
Once the machine is at full RPM, engage the
feedwheels in the forward direction.
2.
Refer to feeding diagram (Figure 1).
A. Follow the travel path.
B. Feed only from the side of the infeed tray.
C. Release the limb or log.
D. Turn away and keep moving after releasing
the limb or log and from the infeed hopper.
3.
Feed large, or butt end, of the branch or log into
the infeed hopper  rst.
4.
If the limb or log does not feed, it may need
repositioned. To reposition, read the following
steps:
A.
Reverse the feedwheels, reposition
the limb or log, and feed again.
B.
The log may need to be removed from the
machine to a safe work area and trimmed
before attempting to feed again if it still will
not feed.