B&Q 5397007212969 User Manual

4 x
Cross Head Screwdriver
Drill
Level
3mm
Drill Bit
5mm
Drill Bit
1 x Side
1 x Side
1 x Base
2 x Rail
2 x Support Shelf Rail
1 x Oven Support Shelf
2 x Oven Spacer Panel
1
2
3
4
5
22 x
C
15mm
Panels Hardware
ASSEMBLY GUIDE
Minimum Tools required
Hammer
2 x
D
BASE
Cabinet
Built Under Oven Housing
1
2
3
4
5
4 x
A
2 x
E
2 x
K
25mm
H
50 mm
6
6 x
DD
30 mm
4
5
6
Before you Start …
WARNING: Installation should be performed by a competent person only. This product could
be dangerous if incorrectly installed. All assembly fittings except legs and shelf pegs have
been pre-inserted. If any are missing or there is a problem with the panels, please call the
Helpline on 01769 575500 and our team will get things sorted.
Cleaning – Use mild soap and water only. Do not use abrasive cleaners.
Legs
4 x
S
2 x
U
4 x
T
2 x
V
Please use scissors to open the
bag of fittings and then empty
the contents into a bowl, so
that they do not get lost!
7
7
To protect your kitchen doors from any
excess heat emitted by your oven, it is
strongly recommended that an appropriate
Oven Heat Deflector Kit is fitted around
the oven aperture in this unit. Suitable kits
are available from B&Q and details can be
found in the kitchen price list.

B&Q 5397007212969 Specifications

General

Brand	B&Q
Model	5397007212969
Category	Indoor Furnishing
Language	English

Summary

Before You Start

Safety and Cleaning Instructions

Important safety warnings for installation and cleaning advice.

Support and Accessory Information

Helpline contact and recommendation for oven heat deflector kit.

Assembly Steps

Fit Panels to Base

Attach side and base panels using cams and screws as per diagram.

Install Oven Filler Panel

Fix the oven filler panel to the cabinet bottom using brackets and screws.

Secure Cabinet and Spacer Panels

Attach cabinet side panels and fit oven spacer panels if required.

Fit Cabinet Legs

Attach and adjust the cabinet legs to the underside of the unit.

Level, Join, and Secure to Wall

Level the unit, join panels, and fix to wall using appropriate fittings.

Fit Plinths

Attach plinth panel and clip plate to the front of the cabinet legs.