B&Q WALL User Manual

1 x
2 x
6 x
2 x
2 x
Cross Head Screwdriver
Drill
Level
3mm
Drill Bit
5mm
Drill Bit
1
3
6
5
7
Panels Hardware
ASSEMBLY GUIDE
Minimum Tools required
Hammer
12 x Standard
B
4
WALL
Cabinets
1 x RH Side
1 x LH Side
1 x Top
1 x Base
1 x Back
2 x Shelves for Standard 3 x for Tall
1 x Rail
1 x Centre Muntin
1
2
3
4
5
6
2
6
AA
P
BB
BC
800 -1000mm
Standard and Tall
6
7
18 x Tall
B
H
50 mm
8
8
4 x
K
25mm
Before you Start …
WARNING: Installation should be performed by a competent person only. This product could
be dangerous if incorrectly installed. All assembly fittings except legs and shelf pegs have
been pre-inserted. If any are missing or there is a problem with the panels, please call the
Manufacturers’ Helpline on 01769 575500, and their team will get things sorted.
Video assembly guides can be viewed at www.mycabinetguide.co.uk
Cleaning – Use mild soap and water only. Do not use abrasive cleaners.
Please use scissors to open the
bag of fittings and then empty
the contents into a bowl, so
that they do not get lost!
Hinges Supplied Separately
14 x Standard
2 x
D
F
22 x Tall
F
20mm

B&Q WALL Specifications

General

Brand	B&Q
Model	WALL
Category	Indoor Furnishing
Language	English

Summary

Before You Start Assembly

Installation Safety Precautions

Warning: Installation by a competent person only to prevent potential danger.

Assembly Support and Maintenance

Access online video guides and follow cleaning advice for product care.

Cabinet Assembly Steps

Connecting Cabinet Panels

Assemble main panels using cams and screws as per steps 1 and 2.

Securing Base and Back Panels

Secure the base panel to the back rail using screws as shown in step 2.

Wall Hanging Preparation

Drill holes for wall mounting as per step 3, referring to the provided table.

Shelf Installation

Insert shelf pegs at required positions and rest shelves on them for securing.

Wall Fitting Instructions

Wall Plate Preparation

Split wall plate AA into left and right hand sections before wall mounting.

Securing Unit to Wall

Position and secure wall plates, then insert and lock hanging brackets into panels.

Adjusting Hanging Bracket Height

Use a screwdriver to adjust the height of wall hanging brackets clockwise or anticlockwise.

Joining Cabinets

Drill 5mm holes through side panels and join cabinets using joining bolts.

Door and Frame Fitting

Door Hinge Installation

Insert door hinges into recesses and clip onto hinge plates, adjust screws for door alignment.

Soft Closer System

Fit soft closers to centre muntins or frame panels as per system purchased.

Magnetic Catch System

Install magnetic catch holder and catch, then adjust for optimal door closing.

Handle Installation

Position handles and fix them, ensuring not to drill into shelves.