…CLOSE-UP OPERATION
5
Sound control
Timer Play control
If you have programmed your main
Bang & Olufsen system to start playing
automatically (Timer Play) – for
example to wake you up in the
morning – the speakers in your BeoLink
Passive room can be included as well.
To do so, just press the TIMER key on
the BeoLink Passive receiver. A small
red light in the TIMER key indicates
that your BeoLink Passive room will be
included as well, whenever your main
system starts playing a Timer Play
programming.
Press TIMER again to cut out the Timer
function (the red light disappears).
Volume adjustment
Volume is adjusted quite indepen-
dently of your main Bang & Olufsen
system.
By pressing the volume buttons
∧ or ∨
on the BeoLink Passive receiver, you
can raise or lower the volume level in
the loudspeakers as you like.
Note: See page 9 for further information about
sound.
Note: If your main Bang & Olufsen system is in
stand-by when you switch on the BeoLink Passive,
you will only get sound in the speakers in your
BeoLink Passive room – the loudspeakers in your
main system will not be cut in.
The lower key marked PLAY • on the
BeoLink Passive receiver enables you to
listen-in on a source that is currently
playing in your main Bang & Olufsen
system.
If no source is playing, pressing PLAY •
will switch on the radio* program that
was last playing.
No matter how, whenever you press
PLAY •, the sound from your main
system will be heard instantaneously in
your BeoLink Passive room.
Press PLAY • again briefly, and the
BeoLink Passive switches off – a small,
red light (stand-by indicator) appears in
the PLAY • key.
If you keep your finger on PLAY • for
two seconds, both the BeoLink Passive
and your main system will switch off
simultaneously.
* Note: If your main system consists of a Bang &
Olufsen video system only (with no audio
sources), pressing PLAY • will switch on the TV
program that was last playing.
To Next Page
Loading...
