BeoLink Converter consists of a control box and a mains cable.
BeoLink Converter is used to connect an audio and a video system where
one system is based on Master Link and the other on Datalink
BeoLink Converter can be used both with an audiomaster and a
videomaster. BeoLink Converter has autocon guration, which means that it
can automatically decide if it is in a Master Link video system or in a
Master Link audio system. Con guration takes place after mains
BeoLink Converter can also be used as an ML driver*, which means that it is
possible to connect e.g. a BeoCenter 2300 via the BeoLink Converter to the
Master Link and thereby distribute the sound to all link room products
BeoLink Converters are used in compatibility setups (see section on
recommended compatibility setups, page 17).
In addition to the accessories supplied, the installation also requires a
Master Link cable and plugs, sockets and junction boxes (see also section on
installation types, page 23).
BeoLink Converter, type no. 1161466 cannot be used as an ML driver.
To Next Page
Loading...
Need help?
General
