Need help?Do you have a question about the Bang & Olufsen Beoplay HX and is the answer not in the manual?
General| Type | Over-ear |
|---|---|
| Noise Cancellation | Adaptive Active Noise Cancellation |
| Battery Life (ANC on) | Up to 35 hours |
| Battery Life (ANC off) | Up to 40 hours |
| Bluetooth | 5.1 |
| Driver Size | 40 mm |
| Frequency Response | 20 Hz - 22 kHz |
| Weight | 285 g |
| Impedance | 24 Ohm |
| Charging Time | 3 hours |
| Water Resistance | No |
| Connection | 3.5mm jack, USB-C |
| Colors | Black Anthracite, Sand, Timber, Dark Maroon |
| Sensitivity | 95 dB |
| Microphone | 4 x MEMS for Voice Mics |
| Quick Charge | Yes |
| Voice Assistant | Yes |
Turn on headphones by pressing the right earcup button; indicator flashes blue for pairing.
Use touch controls on the right aluminium disc to play, pause, skip tracks, and adjust volume.
Use touch controls on the right aluminium disc to accept, reject, and end calls.
Switch between Active Noise Cancellation, Transparency, and Neutral using the left earcup button.
Use the round button on the left earcup to activate voice assistant or mute/unmute the microphone.
Charge using USB-C cable; indicator shows green when full, red below 10%.
Long press power button for 2 seconds until light blinks blue to initiate pairing.
ANC & Transparency modes are only available during wireless connection.
Activate and adjust ANC by pressing the left earcup's rectangular button or via the app.
Activate and adjust Transparency Mode by pressing the left earcup's rectangular button or via the app.
Own Voice adjusts your voice volume and filters background noise during calls.
Long press the power button on the right earcup until the LED flashes red to reset.
To Next Page