Delay Timers
Use these menus to set the delay timers. These menus are available only if an output timing delay is selected.
For and , the default is 0.
For , the defaults are:
• 10 milliseconds for 15, 25, and 50 millisecond response speeds
• 1 millisecond for 3 and 5 milliseconds response speeds
Use
and to scroll through the values. Millisecond values do not include the decimal point; seconds values include the
decimal point.
•
1 to 999 ms (when
is selected, the 1 to 9 ms range is available for 3 and 5 ms response times)
• 1.0 to 90.0 s
Totalizer
The totalizer function changes the output only after counting a designated number of targets. After selecting this function,
or become available to define the output duration and or to define required number of
counts before the output changes.
For and , the default is 1 count.
For and , the default is 10 milliseconds. Use and to scroll through the values. Values in millisecond do
not include the decimal point; values in seconds include the decimal point.
• 1 to 999 ms (when or is selected, the 1 to 9 ms range is available for 1.5, 2, 3, and 5 ms response
times)
• 1.0 to 90.0 s
From Run mode, press SELECT to change the display to show the current totalizer count. Pressing SELECT again changes
the display back to the measured distance.
The totalizer count automatically resets after re-teaching the switch point distance or turning the sensor off.
3.2.8 Hysteresis and
Use this menu to set the hysteresis distance around the switch point.
•
—The sensor automatically selects a recommended minimum hysteresis distance relative to the current
switch point distance,
• to
—Enter a user-selectable value (cm) of hysteresis distance relative to the current switch point distance.
Set Distance—The distance from the reference surface that allows stable use, including the effects of temperature and
voltage, to the (standard) sensing object transit position. This is approximately 70% to 80% of the normal (rated) sensing
distance.
Q5X Laser Triangulation Sensor with Background Suppression
14 www.bannerengineering.com - Tel: +1.763.544.3164
To Next Page
Loading...