Baoli KBET18 - User Manual

Risks of not following safety provisions for staff and the truck.

Rules against unsafe conditions and securing raised parts.

Warnings for handling batteries, avoiding short circuits and explosions.

Correct battery connection and using earthed appliances safely.

Risks of hydraulic oil penetration and safe leak detection.

Essential checks, fluid levels, and leak elimination before delivery.

Checks on pedals, brakes, electrical systems, and lubrication points.

Guide to connecting a PC for diagnostics using the SME interface cable.

Steps for installing and navigating the EYEPLUS software.

Overview of EYEPLUS menus: Exit, Setup, Test, Data Logging, Password, About.

Procedure to enter a password for Supervisor mode access.

Accessing Calibration and Flash menus from Supervisor mode.

Selecting active menus and managing the 'PANEL BLANK' message.

Parameters displayed in the Drive menu for twin motor applications.

Parameters displayed in the Drive menu for single motor applications.

Parameters available in the Pump test menu, including voltage, pressure, and temperature.

Parameters shown in the Battery test menu, including voltages and alarms.

List of available calibration functions accessible via the pop-up menu.

Procedure for resetting battery voltage calibration in the standard version.

Additional parameter for discharged battery voltage calibration in the optional version.

Procedure for calibrating the steering sensor voltage.

Steps for calibrating the accelerator pedal sensor voltage.

Details on the second pedal sensor and its calibration procedure.

Procedure for calibrating lift sensor voltage and parameters.

Calibrating ESH parameters and L1, L2, L3 limits for operating modes.

Procedure for modifying percentage values for L1, L2, L3 limits.

Calibrating parameters related to steering, such as deceleration ramps.

Calibrating drive motor parameters like maximum current and speed.

Additional parameters for drive motors like tire diameter and fan temperature.

Calibrating pump motor parameters such as current, speed, and ramps.

Setting maximum speeds for pump and drive motors based on fork height.

Steps for confirming or updating truck model selection when flash memory is programmed.

Confirming or selecting a truck model from a list for programming.

Guidance on selecting correct drive motor system models to prevent errors.

Procedure when flash memory is not programmed, showing 'PANEL BLANK' message.

Choosing a lift truck model from a selection list when the panel is blank.

Starting the flash programming phase after selecting the truck model.