To Next PageTo Next Page
Need help?Do you have a question about the Baotian Classic and is the answer not in the manual?
General| Fuel System | Carburetor |
|---|---|
| Front Brake | Disc |
| Rear Brake | Drum |
| Cooling System | Air-cooled |
| Transmission | Automatic |
Instructions for checking wear on the pivot, gear, spring, and sleeve.
How to check the driving belt for wear, cracks, or fraying and measure its width.
How to check wear on rollers and the driving pulley sleeve, including service allowances.
Removal and checking/assembling procedures for the overrunning clutch.
How to check wear on clutch housing, lining, and transmission pulley spring.
Key considerations before dismantling the crankcase and related parts.
How to measure the clearance of the connecting rod big end on the crankshaft.
How to check wheel rim run-out and replace bearings if noisy or loose.
How to measure the thickness of the brake lining.
Technical specifications for rear wheel runout, brake hub ID, and spring length.
How to check rear wheel run-out and measure the rear brake hub ID.
How to measure the thickness of the rear brake lining.
Technical specifications for battery, magneto, rectifier, and resistor.
Common problems like no power supply, unstable current, and low voltage.
How to check battery voltage and charging status.
How to test charging voltage and current with engine running.
How to check plug contacts and measure resistance of the voltage regulator.
Standard values for spark plug, gap, advance angle, and coil resistance.
Steps to inspect the CDI module, including removing cover and testing resistance.
Procedures for removing the ignition coil and testing its primary and secondary resistance.
How to check spark advance angle using a timing lamp.
Notes on starter motor removal and installation standards.
Inspecting brushes, commutator, and measuring resistance.
Checking the starter relay operation by testing voltage and ground return.
Issues with brake/turn lights, fuel indicator, dim lights, and dimmer switch.
How to measure fuel sensor resistance with float in different positions.
Inspecting handlebar switches like lights, starter, dimmer, and turn light switches.
Testing brake light switches for proper operation using a continuity tester.
Safety precautions regarding battery electrolyte and handling.
Regular maintenance schedule for various scooter parts based on mileage.
Technical specifications for product size, tread, weight, speed, power, and battery.
Common problems like scooter not starting, running weak, or not moving.
Lifting motor coil sub-assembly and inspecting coils and wires for damage.
