8
ECO 550
ECO 650
ECO 750
SAVANNAH ATLANTA
1.7 USING THE APPLIANCE FOR THE FIRST TIME
The gas fire is coated with a lacquer layer resistant to high temperature. During
the first hours of operation, the burning in of the lacquer may result in an
unpleasant smell. This is harmless, however. Operating the gas fire at full capacity
for a few hours, while ventilating the room, will eliminate the smell. Moreover,
deposits may form on the inside off the glass; these can be removed with a dry
cloth when the gas fire has cooled down.
1.8 DAILY MAINTENANCE
l Regulary check that the air supply is still open.
l Ensure that as little dust, and as few particles of cigarette smoke, candles
and oil lamps as possible pollute the air in the room in which the appliance is
used. Heating of these particles by the convection system of the appliance
could lead to discoloration of the walls and ceiling. It is therefore very
important to ensure that the room in which the appliance is located is
sufficiently ventilated. Regularly remove any dust deposits from behind the
control flap by means of a vacuum cleaner.
If the glass is broken or cracked, it must be
immediately replaced before operating the
gas fire again.
l If anything is spilt on the fire, switch it off immediately and wait for it to cool
down sufficiently before cleaning. Never use scouring powder, aggressive
cleaners or fire polish on the gas fire. Use only a dry lint free cloth.
l Barbas heat resistant lacquer in aerosols can be obtained from your
distributor. During the yearly maintenance, the lacquer can be used to repair
small areas of damage.
• Stains on soap stone can be removed by rubbing gently with a washing-up
sponge and drying with a tea towel.
IMPORTANT
The installation must only be carried out by a
CORGI registered installation engineer.
To Next Page
Loading...
