34
ECO 40 / 52 / 55
We recommend that you maintain a substantial layer of ash (2 - 3 cm). This not
only forms a protective layer for the base of the appliance but also signi• cantly
reduces consumption of fuel and allows new wood to catch light easier.
When loading the stove with fuel, two blocks measuring 15 cm long and 30 cm
perimeter (ECO 40), (35 cm perimeter (ECO 52)), (40 cm perimeter (ECO 55))
is suf• cient. Do not add more fuel until the previous fuel has burned down to the
charcoal stage. This is after approximately 45 minutes.
The • ames are then almost no longer visible. Do not leave the door open longer
than necessary.
Weather conditions
In order to reduce pollution and any other inconvenience, we advise not • ring up
the stove when there is no wind, or in foggy/misty conditions.
Smoke development
Your stove has been designed to be used with the load/observation door closed.
Should you use it with the door open, under certain circumstances (presence of
mechanical ventilation, draught, differences in barometric pressure) smoke may
enter the room in which the stove is situated.
Use of the stove
Your stove is suitable for periodic use.
The appliance is • tted with a soapstone or steel casing on the outside.
Soapstone casing: This casing • rst absorb a lot of heat (heat accumulation)
before emitting (radiation / convection) warmth.
Using the stove for short spells is inef• cient.
The stove may only be positioned in a place where the location, construction
and activity in the room can accommodate it without danger.
Ventilation
When using the stove, ensure a good supply of fresh air. After all, the
combustion air is taken from the room where the stove is located. Turn on the
• ue gas fan if the • ue is • tted with one.
Spare parts
Any replacement parts must be new, original parts. Use of non-original/
reconditioned parts will invalidate your warranty.
To Next Page
Loading...