11
D. THE GAS SYSTEM
1. GAS AND REGULATOR INFORMATION
This pizza oven is designed for Propane (LPG) gas use only. Gas bottles with a "POL"
connection are to be used with this pizza oven. Suitable regulators must have an outlet
pressure of 2.75 kPa. You must have the proper regulator and bottle in order for the pizza
oven to operate safely and eciently. Ensure that a 100% propane (LPG) rellable gas
cylinder currently certied to Australian Standard AS2030.1:2009 is used. Do not use
disposable gas cylinders. Please note the hose and regulator supplied with this pizza oven
are approved types and are specically designed for use with your pizza oven.
2. CONNECTING THE HOSE AND REGULATOR TO THE GAS BOTTLE
— Only use the hose assembly supplied with this appliance for direct connection to the
cylinder – DO NOT USE ADAPTORS. Do not use any other hose assembly. Check the
gas hose for damage or signs of abrasion before each use.
— Keep the hose clear of sharp edges and hot surfaces.
— Avoid twisting or kinking the exible hose.
— If damaged, do not use the hose and replace it immediately. If there is any doubt, contact
the customer service line on 1300 301 392.
— Make sure all pizza oven and gas cylinder control knobs are in the o position. Connect
the regulator to the gas cylinder by inserting the regulator connection into the gas bottle
outlet. This is tightened in an anti clockwise motion.
— Firmly hand tighten and then be sure to check for leaks at all gas connections.
BE SURE TO CHECK FOR LEAKS AT ALL CONNECTIONS
P.O.L. LEFT HAND THREAD
7/16" - 20 UNF THREAD
ARROSTO GAS PIZZA OVEN-Manual_v5.indd 11 19/12/17 1:28 pm
To Next Page
