Barco CINE 6 - Deletion of All Blocks; All Settings to Midpos; Undo All Settings to Midpos

Service Mode
R5976381.01 BARCO CINE6 31012002 __________________________________________________________________________ 7-7
All settings to midposition
This item is password protected.
Highlight All settings to midposition using the arrow keys and press ENTER to set all settings to midposition.
A confirmation menu will be displayed first.
In this menu :
ENTER will set all settings to their midposition.
EXIT will cancel the operation.
Undo all settings to midposition
When 'All settings to midposition' is selected, this action can be cancelled by selecting 'Undo all settings to midposition' in the Memory
Management menu. Press ENTER after selecting this option.
An Undo is possible as long as the projector is on the same source (i.e. same adjustment block) even when some adjustments
like geometry or convergence are readjusted. When Undo is selected, all settings are restored to their previous settings.
Deletion of all blocks
Highlight DELETE ALL BLOCKS using the arrow keys and press ENTER.
A confirmation screen will be displayed. Press ENTER to delete all blocks, or press EXIT to return without deleting anything.
Note : Once ENTER is pressed, all block headers and settings are permanently removed and cannot be restored.
MEMORY MANAGEMENT
or
<EXIT> to return
then <ENTER>
Select with
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MID POS
R & B CONVERGENCE TO MID
DELETE ALL BLOCKS
<EXIT> to cancel
<ENTER> to Confirm
All 24 blocks
will be deleted !
MEMORY MANAGEMENT
or
<EXIT> to return
then <ENTER>
Select with
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MID POS
R & B CONVERGENCE TO MID
SET TO MIDPOSITION
<EXIT> to cancel
<ENTER> to Confirm
All settings
in current blocks
will be overwritten !
MEMORY MANAGEMENT
or
<EXIT> to return
then <ENTER>
Select with
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
UNDO MIDPOSITION
R & B CONVERGENCE TO MID