Barco CR series Reference Manual

2. Communication protocol definitions
Error code Error message Description
!00002 Not available
Logic conflict prevents command being available. For ex ample, contrast is not
available wh en the projec tor is searching for sources.
!00003 Not implem ented
Comm and not available for this projector configuration. See relevant commen ts
section in ASCII commands for information.
!00004
Value out of range
Value is not within v alid range.
2.3 Examples
SET commands
Command
Description
:POWR1’CR’
Set power on
%001 POWR 000001’CR’
Acknowledge power on
Command
Description
:BRIG 60’CR’
Set brightness to 60
%001 BRIG 000060’CR’
Acknowledge brightness
Command
Description
:CNTR R1’CR’
Increase contrast
%001 CNTR 000061’CR’
Acknowledge increase contrast
Command
Description
:CNTR R-2’CR’
Decrease contrast
%001 CNTR 000059’CR’
Acknowledge decrease contrast
SET commands with target
Command Description
:TATB 1 3’CR’
Set aspec t trigger behavior 16:10 to off
%001 TATB 000001’CR’
Acknowledge set as pect trigger behavior 16:10 to off
GET comma nds
Command
Description
:CNTR?’CR’
Get current v alue contrast
%001 CNTR 000059’CR’
Acknowledge get current value contrast
Command
Description
:BRIG ?N’CR’
Get minimum value brightness
%001 CNTR 000000’CR’
Acknowledge get minimum value brightness
GET commands with target
Command
Description
:TATB ? 3
Get a spect trigger behavior 16:10
%001 TATB 000001 ’CR’
Acknowledge get aspect trigger beha vior 16:10
601–0381–00 F(L)35, FS35 IR, F85 21/10/2015 5
All manuals and user guides at all-guides.com

Barco CR series Specifications

General

Brand	Barco
Model	CR series
Category	Projector
Language	English