Version 1.25 | E3 IP66 Outdoor Rated User Guide | 3www.bardac.com
General Information
It is the responsibility of the installer to ensure that the equipment or system into which the product is incorporated complies with all
relevant legislation and codes of practice which apply in the country of use.
CE Marking
All Bardac products intended for use within the European Union carry the CE mark to indicate compliance with European Directives.
A declaration of conformity is available from the website, www.bardac.com
For compliance with the European EMC Directive, the necessary guidance is provided within this document and it is the responsibility
of the installer to ensure this guidance is followed to ensure compliance.
UL Conformity
A list of currently listed products is available from the UL website, www.ul.com.
For compliance with UL requirements, the necessary guidance is provided within this document and it is the responsibility of the installer
to ensure this guidance is followed to ensure compliance.
Copyright Bardac Corporation © 2021
All rights reserved. No part of this User Guide may be reproduced or transmitted in any form or by any means, electrical or
mechanical including photocopying, recording or by any information storage or retrieval system without permission in writing from the
publisher.
2 Year Warranty
All Bardac E3 drive units carry a 2 year warranty against manufacturing defects from the date of manufacture. The manufacturer
accepts no liability for any damage caused during or resulting from transport, receipt of delivery, installation or commissioning. The
manufacturer also accepts no liability for damage or consequences resulting from inappropriate, negligent or incorrect installation,
incorrect adjustment of the operating parameters of the drive, incorrect matching of the drive to the motor, incorrect installation,
unacceptable dust, moisture, corrosive substances, excessive vibration or ambient temperatures outside of the design specification.
The local distributor may offer different terms and conditions at their discretion, and in all cases concerning warranty, the local
distributor should be contacted first.
This user guide is the “original instructions” document. All non-English versions are translations of the
“original instructions”.
The contents of this User Guide are believed to be correct at the time of printing. In the interest of a commitment to a policy of
continuous improvement, the manufacturer reserves the right to change the specification of the product or its performance or the
contents of the User Guide without notice.
This User Guide is for use with version 3.11 Firmware
User Guide Revision 1.25
Bardac adopts a policy of continuous improvement and whilst every effort has been made to provide accurate and up to date
information, the information contained in this User Guide should be used for guidance purposes only and does not form the part of
any contract.
When installing the drive on any power supply where the phase-ground voltage may exceed the phase-phase voltage
(typically IT supply networks or Marine vessels) it is essential that the internal EMC filter ground and surge protection
varistor ground (where fitted) are disconnected. If in doubt, refer to your Sales Partner for further information.
This manual is intended as a guide for proper installation. Bardac cannot assume responsibility for the compliance
or the
non-compliance to any code, national, local or otherwise, for the proper installation of this drive or associated equipment.
A hazard of personal injury and/or equipment damage exists if codes are ignored during installation.
This E3 drive contains high voltage capacitors that take time to discharge after removal of the main supply. Before working
on the drive, ensure isolation of the main supply from line inputs. Wait ten (10) minutes for the capacitors to discharge to
safe voltage levels. Failure to observe this precaution could result in severe bodily injury or loss of life.
Only qualified electrical personnel familiar with the construction and operation of this equipment and the hazards involved
should install, adjust, operate, or service this equipment. Read and understand this manual and other applicable manuals
in their entirety before proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
To Next Page
