13
~10 Easy Steps to a Perfect Hot Tub!~
1. Fill your spa with water that has NOT gone through a water softener. If you have very hard water, lots of
rust, or are using well water use a pre-lter on the end of your hose (Not included). Remove the Hot
tub lter, and place the end of the hose in the lter compartment. While lling add Spa Bright per the
directions on bottle. When full: replace the lter, and turn on the jets, close the cover, and let it heat.
2. After at least an hour, add a cap full of Spa Shock directly into the center of the spa. Turn the jets
back on, close the cover, and let it heat again.
3. When the spa reaches at least 90 degrees, turn the jets on again, close the cover, and let it heat.
4. When the spa reaches the right temperature it is ready to use. Use a Test Strip from the bottle. Use
according to the directions on the bottle. The Chlorine may read low, this is normal.
5. Both the Alkalinity and the PH are adjusted together. Always adjust the Alkalinity rst, then the PH.
Read the Alkalinity on the test strip. If it is too high add PH Down (a cap full) every 4 to 6 hours until it
reads in the “Okay” range. If the Alkalinity is too low add Alkalinity Up (a cap full) every 4 to 6 hours
until it reads in the “Okay” range.
6. Once the Alkalinity has been in the “Okay” range for 48 Hours, then read the PH. If the PH is too high
add PH Down at the rate of 1 teaspoon every 4 to 6 hours until it is in the “Okay” range. If the PH is too
low add PH Up at the rate of 1 teaspoon every 4 to 6 hours until it is in the “Okay” range.
7. Once a week re-test the PH and Alkalinity and adjust if necessary.
8. Every other week add Spa Bright per directions on the bottle, and add water to the proper level. On
opposing weeks, add a cap full of Spa Shock and 2 ounces of Clear Spa. Wait at least 6 hours, but
not more that 24 hours, and then remove and rinse your lter. You must turn off the hot tub at the
breaker before removing the lter.
9. If your water gets cloudy, or has a smell add a cap full of Spa Shock. Then wait at least 6 hours, but
not more than 24 hours, and then remove and rinse your lter. You must turn off the hot tub at the
breaker before removing the lter.
10. Last and very important! Be patient and go slow. Your Ozone system will do most of the work if you
give it time. You should only drain and re- ll your spa once a year!
Note: The initail time period immediately after a fresh water ll is the most important and unpredictable
time of this process. Don’t be discouraged if your water gets worse before it gets better. The worst thing
you can do is add to much of anything. The second worst thing is get frustrated, or impatiant and start
over.
Spa First Aid Kit
To Next Page
Loading...