11
~ Maintenance ~
Proper Water Level
It is normal for the spa to lose approximately one inch of water per week. The water loss is due to evaporation
and run off from people exiting the spa. Please be mindful of this and add water as necessary. If the water
level drops below the lter level then the pumps will draw in air. This will cause the pumps to ‘air-lock’ and can
cause error codes that will prevent the heater from turning on.
Filter Maintenance and Replacement
Proper maintenance of the spa’s lter is very important. The lter helps to clean the spa from algae, bacteria,
hair, debris, and other solids that enter the spa. Failing to clean the lter will place an unnecessary strain on
its respective pump. Additionally, a dirty lter will result in dirty water. Clean the lter at least once a month. Do
not use a pressure washer.
To clean the lter:
1. Shut off power to the spa.
2. Remove the lter from the spa. Hold the lter at a 45º angle and spray it off with a garden hose.
3. Re-insert the lter in the spa.
It is of equal importance that the spa lter be replaced periodically. The bers in the lter
loosen over time, allowing more particles to pass through them. A standard cartridge lter needs to be
replaced every six months at a minimum.
Draining the Spa
The water needs to be replaced at least once a year. Always remember to shut off power at the breaker before
draining the spa.
The most common way to drain the spa is with the drain valve. The drain valve is a red handled spigot located
in the main access panel. Attach a garden hose to the valve and turn the spigot into the open position to
release the water. Be sure to close the spigot before relling the spa.
Another way to drain the spa is by means of reverse siphon. The steps for this method are as
follows:
1. Place one end of the garden hose in the spa and connect the other end to a faucet.
2. Turn the faucet on to ll the garden hose with water.
3. Once the garden hose is full, turn off the water and disconnect it from the faucet. Be sure this end of the
garden hose is at a lower elevation than the end in the spa.
4. The water will now drain out of the spa.
Cover
While the spa cover is very sturdy, it is not meant to withstand excessive weight. Never stand on the cover.
Remove snow or other items that accumulate on the cover promptly to avoid causing it to misshape or
otherwise become damaged.
To Next Page
Loading...