BarefootSpas PL8 - First Things First; Choosing where to place the spa

7
~ First Things First ~
The spa must be installed on a sturdy, at surface that is built to code. Consult a building inspector or a
licensed contractor
When properly installed, the spa base will rest at on the supporting surface. Do not attempt to shim the spa
or place in an otherwise unleveled surface. Failure to place the spa on a level plane will cause the unit to
distort, collapse, or crack. It is your resonsibility to ensure the chosen location is pefectly at and level. Any
such damage caused by improper installation will not be covered under the warranty.
The surface design and material used to support the spa should meet local building regulations and should be
veried before installing the spa.
Additionally, make sure the spa is accessible to service technicians. Leave at least a three feet of open space
for any side of the spa housing a pump.
The spa must be installed on a sturdy, at surface that is built to code.
Choosing where to place the spa requires careful consideration.