Dialog User Level (continued)
Dialog
item
Value Function/Description
Only models with analog output:
*
0 ... xxx Scale the analog output - start value (e. g. 0 bar = 4 mA)
*
0 ... xxx Scale the analog output - end value (e. g. 400 bar = 20 mA)
(output signal start value always corresponds to the display initial value, e. g. 0
bar = 4mA)
Maximum turn-down 4 : 1, i.e. at values below 25 % of the measuring range
the analog output is switched off
0 ... xxx Display of peak value „Max“ (xxxx: = max. 125 % f. s.)
Delete the maximum value memory
= no deletion
= delete value
Error display:
= no error
= exceeding pos. measuring range
= exceeding neg. measuring range
= sensor error
= error switching output 1
= error switching output 2
= data error (EEProm)
= program error
= calibration error
= error analog out
IMPORTANT
When changing units from psi to bar or bar to psi, the switching point values must be changed
accordingly.
* Flashing of the mean segment signals a negative setting value.
Operating Instructions
Dual pressure switch Switch 2000
Dual Temperature Switch TempSwitch 2000
1
Intended Applications....................................................................................................2
2 Safety Instructions .........................................................................................................2
3 Standards........................................................................................................................3
4 Warranty/Guaranty .........................................................................................................3
5 Installation/Commissioning .......................................................................................... 3
6 Maintenance/Cleaning ...................................................................................................4
7 Technical Data ................................................................................................................5
8 Operation.........................................................................................................................6
9 Programming ..................................................................................................................6
10 User Level Dialog Switch 2000/TempSwitch 2000 ......................................................7
Barksdale GmbH
Dorn-Assenheimer Straße 27
D-61203 Reichelsheim
Tel.: +49 (6035) 949-0
Fax: +49 (6035) 949-111 and 949-113
email: info@barksdale.de
Internet: www.barksdale.de
1
8
Art. no.: 923-1440
Index O, 10.05.2011
Software-Version: V 2.1 and higher
Specifications are subject to changes
without notice!
To Next Page
Need help?
General
