9
Unpacking
Unpack furnace from the box and remove
packing material from inside furnace cham-
ber. The furnace is supplied with a three wire
cord and plug.
Site Selection
Install furnace on a sturdy surface and allow
space for ventilation. The furnace should be
installed at least six inches away from any
combustible material.
Electrical Connections
The electrical specifications are located on
the specification plate on the back of the fur-
nace. Consult Barnstead/Thermolyne if your
electrical service is different than those listed
on the specification plate. Prior to connecting
your furnace to your electrical supply, be sure
the ON/OFF switch is in the OFF position.
Installation
Warning
Do not mount on a surface of
flammable material. The furnace
should be installed at least six
inches away from any com-
bustible material.
Warning
Use a properly grounded electri-
cal outlet of correct voltage and
current handling capacity.
To Next Page
Loading...
