825TKL OWNER’S MANUAL 10/17/22 Page 6 of 22
OPERATOR TRAINING
Rental companies should demonstrate all the machine operations to each rental customer
including:
• Starting up the engine.
• Loading the Track Loader onto the trailer and securing it for road transport.
• Unloading the Track Loader from the trailer.
WARRANTY OF BARRETO MANUFACTURING EQUIPMENT
Barreto Manufacturing, Inc. warrants all BARRETO equipment to be free of defects in material and
workmanship for a period of one (1) year. Warranty period begins on date of delivery to the original
user.
This warranty is in lieu of all other warranties, whether written or implied, and is limited to:
1. Replacement of parts returned to the dealer and/or factory and determined defective upon
inspection. (Replacement for parts to dealers shall be at dealer cost plus shipping
charges.)
2. Time for pick-up and/or delivery, transportation of service calls by dealers is
excluded. Manufacturer reserves the right to determine reasonable time required
for repair.
Warranty does not apply to damage caused by abuse or neglect. Time and materials required
for normal maintenance and service are also excluded from warranty coverage.
Engines, engine attached fuel tanks, engine accessories, batteries and tracks are warranted by
the original manufacturer and are not covered by the Barreto Equipment Warranty.
Wear parts such as sprockets, track rollers, bearings, bushings etc. are excluded unless it can
be determined that a defect has contributed to premature wear.
MAINTENANCE PREPARATION
Only trained & qualified personnel should perform maintenance or repairs of the Track Loader.
Before performing any service, maintenance, adjustments, repairs, or off-season long-term storage,
follow the SHUT DOWN PROCEDURE in the OPERATOR’S MANUAL.
Do not touch the engine, muffler, or any of the hydraulic components until cool.
WARNING: Muffler and engine get hot enough to cause serious burns. For
the safety of yourself and others, allow enough time for the engine, muffler,
and the hydraulic fluid to cool completely before performing any cleaning or
maintenance.
Avoid contact with hydraulic fluid.
WARNING: When machine is operating, hydraulic fluid is under extreme pressure and can
get under skin and burn or poison.
Read the BATTERY & ELECTRIC STARTER SAFETY INSTRUCTIONS. Disconnect the battery,
removing the negative terminal first by loosening the wing nut where the cable end is secured to a
To Next Page
Loading...
Need help?
General