825TKL OPERATOR’S MANUAL 2/10/20 Page 12 of 28
WARNING: Fuel fumes can catch fire or explode. Do not smoke or allow flames or sparks in
the area.
Do not touch the engine, muffler, or any of the hydraulic components until
cool.
WARNING: Muffler and engine get hot enough to cause serious
burns. For the safety of yourself and others, allow enough time for
the engine, muffler, and the hydraulic fluid to cool completely before
performing any cleaning or maintenance.
See the Engine Manual from Kubota included with the machine for more engine instructions.
Only operate the 825TKL outdoors and avoid breathing engine exhaust and fumes.
COLD WEATHER OPERATIONS: Before operating in cold weather, refer to the Engine Owner’s
Manual for recommended engine oil. Do not spray starting fluid into the air cleaner as engine damage
could result. If the machine is operated at temperatures below +32°F (0°C) then changing the
hydraulic fluid to ISO 46 is recommended. If you do not want to change the hydraulic fluid but want
to operate the machine at temperatures below +32°F (0°C), then do the following:
• Warm up engine at a low speed.
• Gradually increase engine speed, allowing 30 minutes for the hydraulic fluid to warm up.
Reduce the engine speed if the hydraulic pump whines. Pump noise may indicate a lack of hydraulic
fluid flow that could damage the pump.
For frequent starts below 18°F consult your Barreto Manufacturing, Inc. dealer.
DRIVING PROCEDURE
1. Follow engine start up procedure.
2. Securely grasp the handle surrounding the control levers.
3. The left-hand lever controls the track system and speed. Increasing the lever movement forward
or backwards will increase the speed of the unit.
4. Moving the left-hand lever left or right will drive the tracks in that direction
5. The right lever controls the lift arms and tilt of the attachment plate. Pulling the lever back will
raise the arms, pushing forward will lower the arms. Moving the lever left will tilt the attachment
plate upward, moving it to the right will tilt the attachment plate downward or away from the
operator.
6. Pushing the right-hand lever fully forward will enable the float action of the lift arms, allowing
the attachment to follow the contour of the ground.
NOTE: the 825TKL ride platform contains an Operator Presence Switch which will disable all
machine functions if the operator steps off the platform. The operator must be standing on the
platform for all driving, lift arm or tool functions to operate.
To Next Page
Loading...
Need help?
General