825TKL OPERATOR’S MANUAL 2/10/20 Page 13 of 28
OPERATIONAL INCLINES
Do not operate the 825TKL on a side hill greater than 20°. Doing so may cause the unit to tip over
and cause damage to the operator and machine.
ATTACHMENTS
The 825TKL is designed to use a wide variety of industry-standard attachments from multiple
manufacturers. The attachment system consists of a mount plate connected to the lift arms at the front
of the machine. This plate also contains two lock pins to prevent the attachment from disconnecting
while in use.
To connect to an attachment, tilt the attachment plate down toward the desired tool and drive the
attachment plate into the pocket on the attachment. Once the attachment plate is fitted to the pocket,
To Next Page
