825TKL OPERATOR’S MANUAL 2/10/20 Page 18 of 28
operator’s right thumb. The upper button controls TOOL 2. The operator can then switch the tool
flow forward or reverse. The TOOL 2 switch can be pressed FWD or REV, but will spring to OFF
when not pressed.
NOTE: If the operator steps off the ride platform, the operator must press the “LF Tool” button
again to enable the tool. The presence switch on the ride platform will disable the tool function if
operator steps off the platform.
HIGH-FLOW ATTACHMENTS (HF Tool, Tool 1)- Tools such as a Trenchers, Augers, Mowers
and similar attachments will have a hydraulic motor. These attachments will need to be attached to
the High-Flow auxiliary quick-connect fittings on the right side of the lift arms.
To enable TOOL 1, press the “HF Tool” button on the right side of the display panel. This will allow
the operator to use the High-Flow Auxiliary lines. The lift arm joystick has two buttons controlled by
the operators right thumb. The lower button controls TOOL 2. The operator can then switch the tool
flow forward or reverse. The TOOL 1 switch will stay locked in FWD, REV or OFF when not
pressed.
NOTE: If the operator steps off the ride platform, the operator must press the “HF Tool” button
again to enable the tool. The presence switch on the ride platform will disable the tool function if
operator steps off the platform.
To Next Page
