13SGH-16SGB OWNER’S MANUAL 8/29/18 Page 4 of 11
HOUR METER
The DGI® TACH/HOUR hour meter tracks the hours of machine operation in order for routine
maintenance to be performed on a timely basis.
Your DGI® hour meter is pre-set at the DGI® factory to go into Flash Alert mode at 25-hour
intervals. Although the engine manufacturer does not require changing engine oil this often, due
to heavy-duty use and extreme conditions inherent to tiller use, Barreto Manufacturing
strongly recommends frequent oil changes.
Refer to this manual for equipment service requirements and to the Engine Manual for other
engine service requirements.
While Flash Alert is active, hold the tip of the RESET TOOL (Key Kancel Wand) against the
meter as shown. Within several seconds, the display will stop flashing indicating the Service
Interval has been reset. If the wand gets lost, a small mechanic’s pick-up magnet will work.
RESET TOOL
To Next Page
Loading...
