Barrette 73013706 - Page 4

4
1
1
Mark the fence location using string and line stakes.
Mark the fence location using string and line stakes.
Mark the fence location using string and line stakes.
2
2
Dig post holes 12" in diameter 36" deep. Use the Center to Center
Dig post holes 12" in diameter 36" deep. Use the Center to Center
Dig post holes 12" in diameter 36" deep. Use the Center to Center
measurements of the fence model being installed for the Center to Center
measurements of the fence model being installed for the Center to Center
measurements of the fence model being installed for the Center to Center
Post Distance.
If a fence panel is being used that is less than the width of a full panel, or if
If a fence panel is being used that is less than the width of a full panel, or if
If a fence panel is being used that is less than the width of a full panel, or if
posts are being used other than 5" in width, measure the width of the panel
posts are being used other than 5" in width, measure the width of the panel
posts are being used other than 5" in width, measure the width of the panel
and add the width of one post, that will be the Cente
and add the width of one post, that will be the Cente
and add the width of one post, that will be the Cente
r
-to-Center post distance
of the holes.
3
3
If frost line exceeds 30" dig hole to the appropriate depth and then add
If frost line exceeds 30" dig hole to the appropriate depth and then add
If frost line exceeds 30" dig hole to the appropriate depth and then add
6" of gravel for post drainage. Add concrete according to manufacturers
6" of gravel for post drainage. Add concrete according to manufacturers
6" of gravel for post drainage. Add concrete according to manufacturers
instructions until a depth of 30" remains.
instructions until a depth of 30" remains.
instructions until a depth of 30" remains.
Set post in hole ensuring it is plumb and level. Fill hole with concrete
Set post in hole ensuring it is plumb and level. Fill hole with concrete
Set post in hole ensuring it is plumb and level. Fill hole with concrete
according to manufacturers instructions. Go to step 5.
according to manufacturers instructions. Go to step 5.
according to manufacturers instructions. Go to step 5.
4
4
If frost line does not exceed 30", insert 6" of gravel into bottom of both holes
If frost line does not exceed 30", insert 6" of gravel into bottom of both holes
If frost line does not exceed 30", insert 6" of gravel into bottom of both holes
then set post in ground ensuring it is level. Ensure first post is plumb and
then set post in ground ensuring it is level. Ensure first post is plumb and
then set post in ground ensuring it is level. Ensure first post is plumb and
level and then add concrete according to manufacturers instructions.
level and then add concrete according to manufacturers instructions.
level and then add concrete according to manufacturers instructions.
Center to Center Post Distance
30"
Frost
Line
6"
Profundidad de
penetración del
congelamiento
12"