T e c h 3 0 0 User Guide R.59.1 2020
16 | P a g e
VEHICLE DATA
This menu gives access to specific screens that display the previous read TPM data sorted by
registration or model as detailed above.
This option is only useful if a registration is entered with each
tested vehicle. It will sort the saved data by registration.
Allows to search a vehicle with a specific registration. Use the
Up Arrow to start with upper case, the Down Arrow for
numbers and lower case, Test to enter the next character, and
Enter to start searching.
Stored data will be sorted by model.
To enable Bluetooth, select “My Tool” > “Networks” >
“Bluetooth” and connect to TPMS Desktop to upload all stored
data.
Deletes all stored data on the tool that have already been sent
to the TPMS Desktop.
If one data set is selected, it is possible to get further information about the sensor and the
OBD, to directly access the Program Sensor section and to print the data via the Bluetooth
printer.
TOOLKIT
Allows to test the signal strength emitted by a remote keyless entry.
Select RKE Test, hold the Key Fob and press the function buttons on
the Fob. The TECH300 will check only for a signal present. When
performing relearn processes that use the Key Fob it is important to
verify that the Key Fob is transmitting.
Allows operator to search for sensor signals. This feature is used for
advanced diagnostics to determine if signals may be causing issues
during sensor activation and vehicle relearns.
To Next Page
Loading...