Barton 95546 - OPERATION and STORAGE; SMOKING; AFTER USE; CLEANING AND STORAGE

OPERATION and STORAGE
6
SMOKING:
7. Once the charcoal is glowing, scatter moist smoking chips or something similar over the charcoal.
8. Place the smoking rack (9) into the upper drum on the holders at the top. Make sure that the feet are placed
in the recesses which are provided for them.
9. Place the upper drum on the lower drum. Make sure that they t correctly.
10. Either place the items for smoking onto the rack or hang them on the hooks (19) and then hang them in
the smoking rack.
ONLY hang up the items for smoking once the fuel is covered by a later of ash.
11. Place the lid on the upper drum. The thermometer on the lid displays the temperature prevailing in the
device.
12. Once the items for smoking are fully smoked, carefully remove the hooks from the smoking rack.
AFTER USE:
1. After use, allow the charcoal, rewood or similar items to fully burn out or extinguish them with sand.
2. Allow the device and the fuel to cool down completely and then clean it thoroughly.
3. Dispose of the ash and any remaining fuel in an environmentally friendly manner.
CLEANING AND STORAGE:
CAUTION - Danger of burns! The housing, all accessories and the fuel may also still be hot after the re has
been extinguished. Wait until the device and the fuel have fully cooled down!
• Under no circumstances should you use any corrosive or abrasive cleaning agents, rough sponges or
knives to clean the device. These could damage the surfaces.
1. Remove the parts that have been used in the reverse order (see the “Use” chapter).
2. Clean all accessories with warm water and a little mild detergent. Over time, the effect of the heat may
cause discolouration to the re bowl (15).  However, this does not restrict the performance of the device.
3. Dry all accessories thoroughly before everything is reassembled and stored away.
4. Store the device in a dry place that is protected from sunlight and is not accessible to children and
animals.
DISPOSAL:
Dispose of the packaging material and the article in an environmentally friendly manner and take
them to a recycling centre. Further information is available from