What to do if my Base aire AirWerx 120X Dehumidifier display is blank?
If the display is blank, first check the power cord to ensure both ends are properly plugged in. If the issue persists, reset the power, as there may have been a power outage.
What to do if my Base aire AirWerx 120X shows the E4 trouble code?
If your dehumidifier displays the E4 trouble code, it indicates a problem with the pump. Verify that the pump is correctly installed and functioning. If it is, unplug the unit for two minutes, and then restart it.
What to do if my Base aire AirWerx 120X has no airflow?
If there is no airflow, the filter may be dirty, so try cleaning it. Also, check the air inlet and outlet to ensure they are not blocked. Clear any blockage if present.
What does the LO error code mean on my Base aire AirWerx 120X Dehumidifier?
The LO error code indicates that the room temperature is below 33 degrees. Increase the room temperature so that it is within the operating range (above 33 degrees). If the error still displays, check the sensor.
What does the HI error code mean on my Base aire Dehumidifier?
The HI error code means that the room temperature is above 105 degrees. To resolve this, decrease the room temperature so it is within the operating range (below 105 degrees). If the error persists, check the sensor.
What does the E1 trouble code mean on a Base aire Dehumidifier?
The E1 trouble code indicates a humidity sensor or communication error. Check to ensure that the sensor wire is connected at both ends. If no issues are visible, the sensor may be faulty.
Instructions for proper placement of the dehumidifier unit on a level surface.
Steps to connect the drain line hose to the unit and ensure a secure fit.
Final connection step for the dehumidifier to a suitable electrical outlet.
Explanation of the power button functions for turning the unit on and off.
Details on using up/down arrows to set the desired humidity setpoint.
Steps to turn on the dehumidifier using the power key.
How to use the arrow keys to set the desired humidity level.
Procedure for turning off the dehumidifier, noting the fan delay.
Details on automatic and manual water drainage operations via the condensate pump.
General| Model | AirWerx 120X |
|---|---|
| Category | Dehumidifier |
| Power Supply | 115V/60Hz |
| Refrigerant | R410A |
| Water Removal (Pints/Day) | 120 |
| Water Tank Capacity | No Tank (Designed for continuous drainage) |
| Noise Level | 58 dB(A) |
| Operating Temperature | 33°F - 105°F |
To Next Page
