Technical
Characteristics
• Category: Pressure regulated propane
• Fuel: 16.4 oz. disposable propane cylinders
#F235744- 3 Burner Standard Stove:
2 x 10,000 BTU/HR - 1 x 6,400 BTU/HR
#F235782 - 3 Burner Deluxe Stove:
2 x 10,000 BTU/HR - 1 x 6,400 BTU/HR
DANGER
• Foroutdooruseonly.
• Neveruseinsidehouse,camper,tent,vehicle
or other unventilated or enclosed areas. This
stoveconsumesair(Oxygen)andproduces
carbonmonoxide(CO).Donotusein
unventilated or enclosed areas to avoid
endangering your life.
CAUTION
SERVICE SAFETY
• Keepallconnectionsandttingsclean.Inspect
propane cylinder and stove propane connections
for damage before attaching.
• Duringset-up,checkallconnectionsforleaks
usingsoapywater.NEVERUSEAFLAME!
Bubbles from using soapy water indicate a
leak. Check that the connection is not cross-
threaded and that it is tight. Perform another
leak check. If there is still a leak, remove the
cylinder and contact Basecamp service for
support. 9800.251.0001.
• Useasacookingdeviceonly.Neveruseasa
space heater or leave unattended while lit.
Never alter in anyway or use with any device or
part not expressly approved by Basecamp.
• Cleanstovefrequentlytoavoidgrease
accumulationandpossiblegreaseres.
WARNING
BURN HAZARD
• Neverleavestovesunattendedwhen
hot or in use.
• Keepoutofreachofchildren.
WARNING
Not for home or
recreational vehicle use.
We cannot foresee every use with which may be
madewithourproducts.Checkwithyourlocalre
authorityifyouhavequestionsaboutuse.Other
standards govern the use of fuel gases and heat
producingproductsforspecicuses.Yourlocal
authorities can advise you regarding these codes
and ordinances.
• Usethepresetregulatorthatcamewith
appliances.Donoattempttoadjust.
• UseonlyBasecampaccessoriesorparts.
Duringstoveset-up,checkallttingsfor
leaksusingsoapywater.Neveruseaame.
Set Up
CARBON MONOXIDE HAZARD
NOTE: Use only 16.4 oz. disposable propane
cylinders. The LP gas cylinder(s) used with
portable propane stoves must be constructed
and marked in accordance with the
specications for LP-gas cylinders of the
U.S. Department of Transportation or Transport
Canada, CAN/CSA B339
1.
Remove and inspect all
components from package.
2.
Open Lid
3.
Position wind
guard as
desired.