• Make sure stoves is cool.
• Move stoves away from ame
(Including pilot lights) and other
ignition sources
• Remove propane cylinder from regulator
and replace protective cap on cylinder
• Remove regulator from stoves
• Lift off grate
Standard Ignition Stoves
To Light (Continued)
Set stove on sturdy, at surface. For
outdoor use only.
Hold lit match
near burner and
open burner
valve.
#F235744 3 Burner Propane Stove
2.
1.
Peizo Ignition Stoves
Set stove on sturdy, at surface. For
outdoor use only.
Select the burner to be ignited and
slowly turn the gas control in a counter-
clockwise direction approximately
¼ of a turn.
#F235782 3 Burner Deluxe Propane Stove
2.
1.
Depress the
Piezo button
rmly to get a
spark from the
electrode
positioned
above the
burner.
3.
Adjust ame with burner valve. Flame should
be blue with a hint of yellow in the tips.
4.
To Turn Off
With the ame still operating, turn the gas
control knob in the clockwise direction until
they are rmly “Off”. Allow the ame to burn
down then extinguish once all remaining gas in
the system has been used.
To Clean
• Keep stove areas clean and free from
combustible materials, gasoline and
other ammable vapors and liquids
• Do not obstruct the ow of combustion
and ventilation air
• A good ame should be blue with
minimal yellow tips on ends of ames.
Some yellow tips on ames are
acceptable as long as no carbon
or soot deposits appear.
• Wipe clean with soft cloth and mild
dish detergent. Do not use abrasives.
Maintenance
If Piezo does not light burner on rst try, close
gas control, wait 10 seconds and go back to
step 2.
5.
To Next Page
