Basler A302f - Page 44

Configuring the Camera
4-6 BASLER A302f
DRAFT
Status and Control Registers for the Camera
Status and Control Registers for Features
Offset Name Notes
600h CUR_V_FRAME_RATE
604h CUR_V_MODE
608h CUR_V_FORMAT
60Ch ISO_CHANNEL
610h Camera_Power Has no effect
614h
ISO_EN
Continuous Shot
618h Memory_Save Has no effect
61Ch
One_Shot / Multi_Shot
620h Mem_Save_Ch Has no effect
624h
Cur_Mem_Ch Has no effect
Offset Name Notes
800h BRIGHTNESS
804h AUTO_EXPOSURE Has no effect
808h
SHARPNESS Has no effect
80Ch
WHITE_BALANCE
When using the A302fc in a YUV output mode, this
register can be used to apply a correction factor to
the U value and to the V value for each pixel. See
Section 3.10.1 for more details.
810h
HUE Has no effect
814h
SATURATION Has no effect
818h
GAMMA Has no effect
81Ch
SHUTTER Exposure time = (shutter value + 1) x 20 µs
820h
GAIN The gain can be set in a range from 0 to 511 (0x000
to 0x1FF). However, settings above 319 (0x13F)
have no effect. The effective range of gain settings
is 0 to 319 (0x000 to 0x13F). See Section 3.6.1 for
more information.
824h
IRIS Has no effect
828h
FOCUS Has no effect
82Ch
TEMPERATURE Has no effect
830h
TRIGGER_MODE Only trigger mode 0 is available.
We
strongly recommend that the trigger input po-
larity be set for high active (1).