Installation Guide
18 Basler IP Camera
If you hover the cursor over an IP Camera host name in the Camera Finder
window, information about the camera will be displayed in a tip window as
shown below. The information will include the camera’s model, current
firmware version, serial number, host name, IP address(es), port number,
and an indication of when the camera was located by the finder. (This
"hover" feature will only work correctly if you are using version 1.2 or higher
of the BIP Finder software and you have version 1.4 or higher firmware in
your camera.)
Note: If a camera is set to use a DHCP assigned IP address or to use a
fixed IP address, the tip window will display two IP addresses for the
camera. This happens because the camera always acquires an auto IP
address in addition to the DHCP assigned address or the fixed address. In
this situation, the camera will have two IP addresses and it can be accessed
by using either IP address.
To Next Page
Loading...
Need help?
General
