Configuring the Camera
Basler IP Camera 11
3. A Camera Configuration menu will open on the left side of the client as shown below. Notice
that the parameters used to configure the camera appear in groups such as the Image Controls
group and the Streaming group.
You can open a parameter group by clicking the + sign beside the group name.
By default, the camera is set so that video stream 0 is an MJPEG stream, and a Live Stream 0 tab
will appear in the client as shown above. A live video stream will appear in the tab.
Click the Stop button to stop live image streaming. (A Start button will appear, which will
let you restart the live stream.)
Click the Snapshot button to capture a single image within a new browser window.
Refresh Rate - The Refresh Rate box displays the rate at which the images displayed in the web
client are refreshed. Use the + and - buttons to change the refresh rate.
Note that changing the Refresh Rate setting will not change the rate at which the camera captures
or streams images. The Refresh Rate setting only affects the rate at which images are displayed in
the web client in your browser. Some browsers perform poorly when set to a high refresh rate.
Opening and closing parameter groups or switching from one tab to another will work very slowly if
the refresh rate is too high. The default refresh rate of 5 fps works well in most situations.
If more than one video stream is enabled, there will be an additional Live Stream tab available for
each enabled stream.
Click the Plugin Help button to get information about installing the plugins needed to
view live streams in your web browser.
To Next Page
Loading...
Need help?
General
