Configuring the Camera
Basler IP Camera 15
3.4 Streaming Parameters
The parameters in the Streaming group are used to control the characteristics of the image area that
will be captured by the camera’s sensor. They are also used to control the characteristics of the
video streams that are output from the camera.
The camera can produce up to three individually configured video streams. The streams are
designated as stream 0, stream 1, and stream 2. Stream 0 is always enabled. Streams 1 and 2 can
be either enabled or disabled. Each stream can be accessed by multiple network users.
For more information about video streams, see Section 3.1 on page 7.
When you open the Streaming parameters group, the camera enters the
"configuration" mode. In configuration mode, the streaming of live images from the
camera is temporarily stopped. Streaming will remain stopped until you close the
Streaming parameters group. When you close the Streaming parameters group,
the camera will return to "normal" mode and image capture and streaming will
resume.
When the Streaming parameters group is open, the images displayed on any Live
Stream tabs in the web client will be refreshed approximately once every second,
but these images will not be streamed out of the camera.
If you close the web browser with the Streaming parameters group open,
streaming will remain stopped! To restart the image streams from the camera,
you must restart the web browser, open the Streaming parameters group, and then
close the Streaming parameters group. When you close the group, streaming will
restart.
To Next Page
Loading...
Need help?
General
