11 – CTRL knob and CTRL CV (-6V to +6V)
The CTRL is an assignable control. The CTRL knob can serve as
astatic control or, when you plug voltage into the CTRL CV input, as an
attenuverter.
To enter ASSIGNMENT mode, hold the SHAPE button for afew seconds.
The currently assigned CTRL destination will start blinking. Set the
destination you want by pressing the button nearest to it. Long-press
the SHAPE button again to return to normal operating mode.
The possible CTRL destinations are (indicated by LEDs):
● Octave (Octave LED)
● Detune (Detune LED)
● Linear FM (Tune LED)
● Exponential FM (Octave and Detune LED)
● OCT OSC Ratio (top OCT OSC LED)
● OCT OSC Exp FM (both OCT OSC LEDs)
● RATIO OSC Ratio (top RATIO OSC LED)
● RATIO OSC Exp FM (both RATIO OSC LEDs)
● FM INDEX modulation (top RATIO and OCT OSC LEDs, press OCT
and RATIO button together)
● Waveshape (Wave LED)
● Folding (Fold LED)
● Ring Modulation (Ring LED)
● Bipolar VCA - applied to MAIN and OCT OSC output (both Ring and
Fold LEDs)
CTRL
To Next Page
Loading...