How to fix little or no material flow in my Batavia Paint Sprayer?
If your Batavia Paint Sprayer has little to no material flow, several factors could be the cause. The nozzle or suction tube might be clogged, so try cleaning them. Ensure the suction tube is properly inserted and the container is tightened to build pressure. Also, the air filter may be clogged, so replace it. The material volume setting might be too low; increase it.
Why is the atomization too coarse with my Batavia Paint Sprayer?
If the atomization is too coarse with your Batavia Paint Sprayer, several issues could be responsible. The material's viscosity might be too high, requiring you to thin it. Alternatively, the material volume may be too large; try decreasing the volume setting. A clogged nozzle or air filter can also cause this problem, so clean or change them, respectively. Also, ensure the container is tightened to provide adequate pressure.
How to reduce overspray with my Batavia MaxxSpray BSG0140-US500?
If you're experiencing too much overspray with your Batavia Paint Sprayer: * Increase the distance between the gun and the object you are spraying. * Decrease the volume setting, as too much material may be applied.
What to do if my Batavia MaxxSpray BSG0140-US500 Paint Sprayer is leaking material?
If your Batavia Paint Sprayer is leaking material, check these potential causes: the nozzle might be loose and needs tightening, or the nozzle or nozzle seal could be worn and require replacement. Material build-up on the air cap and nozzle can also cause leaks, so ensure these parts are clean.
Why does the spray jet pulsate on my Batavia MaxxSpray BSG0140-US500 Paint Sprayer?
If the spray jet of your Batavia Paint Sprayer pulsates, it could be due to a couple of reasons. First, check if the material in the container is running low and refill if necessary. Another cause might be a clogged air filter, which would need to be changed.
General| Model | BSG0140-US500 |
|---|---|
| Type | Airless Paint Sprayer |
| Max Pressure | 3000 PSI |
| Weight | 15.4 lbs |
| Hose Length | 7.5 m |
| Power Source | Electric |
| Voltage | 110 V |
| Power | 500 W |
| Max. Viscosity | 100 DIN-s |
| Nozzle Size | 0.015" / 0.38 mm |
| Motor | 500 Watts |
| Tip Size | 0.015" |
To Next Page
