8
Make sure the tube(s) reach the bottom of the
shampoo/conditioner
38 Insert the other end of your 7’ (or applicable length) tubes onto
black hose barb ttings with metering tips installed.
Make sure handle is in the OFF position because we are about
to turn the water on!
39 Turn on the water supply to the unit.
40 Grab the blue outlet hose rmly, directing it away from yourself.
41 Slowly turn the black handle to the RINSE position until fully
opened. This will purge any air out of the unit.
42 Turn the black handle to OFF position.
43 Turn the grey product selector handle to position 1.
44 Turn the black handle to CLEAN position.
45 Run until you see the shampoo/conditioner ll the 7’
(or applicable length) tube and you start to see sudsy water spraying
through the spray nozzle. The time required for this process will vary
depending on the shampoo/conditioner you use.
46 Turn the grey product selector handle to position 2 and repeat
process above.
47 Turn the grey product selector handle to position 3 and repeat
process above.
48 Turn the grey product selector handle to position 4 and repeat
process above.
49 Once all four shampoos/conditioners are running through the
system you are done!
50 Make sure you turn the black handle to the OFF position.
To Next Page
Loading...