EasyManua.ls Logo

Bauer Compressors MVT26 - Page 99

Default Icon
113 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MVT26
October 2003 Section A Page 99
Allow the compressor to cool before servicing. Whenever the compressor is shut down and over-
heating is suspected, a minimum period of 15 minutes must elapse before opening the crankcase.
Premature opening of the crankcase of an overheated unit can result in an explosion.
Incorrect placement of the inlet and pressure valves in a compressor cylinder head can cause an
extremely dangerous condition. Refer to the appropriate section of this manual before installing or
replacing valves.
Before doing any work involving maintenance or adjustment, be sure the electrical supply has
been disconnected, and the complete compressor system has been vented of all internal pressure.
Failure to follow these warnings may result in an accident causing personal injury and/or property
damage.
Before working on the electrical system, be sure to disconnect the electrical supply from the
system at the circuit breaker or other manual disconnect. Do not rely on the ON/OFF switch to
disconnect the electrical supply.
Installer must provide an earth ground and maintain proper clearance for all electrical compo-
nents.
All electrical installation must be in accordance with recognized national, state, and local elec-
trical codes.
Do not use gasoline, diesel fuel or other flammable products as a cleaning solution.
A compressor which has been used for gas service is unsuitable for air applications. Should the
purchaser and/or user proceed to use the compressor for air service after it has been used for gas,
the purchaser/user assumes all liability resulting therefrom without any responsibility being
assumed by Bauer Compressors, Inc. The purchaser is urged to include the above provision in any
agreement for resale of this compressor.
The use of repair parts other than those listed in this manual or purchased from BAUER Compres-
sors, Inc. may create unsafe conditions over which BAUER has no control. Such unsafe condi-
tions can lead to accidents that may be life-threatening, cause substantial bodily injury, and/or
result in damage to the equipment. Therefore, BAUER Compressors, Inc. can bear no responsi-
bility for equipment in which non-approved repair parts are installed

Table of Contents

Related product manuals