Maintenance and Servicing
Procedures not specifically explained
in
this manual must
be
performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Release the Trigger and unplug the tool from its electrical outlet before
performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1.
BEFORE EACH USE, inspect the general condition
of
the tool. Check for loose hardware, misalignment
or
binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other
condition that may affect its safe operation.
2. Monthly, open the Grease Port, clean out old
grease, and replace with new grease.
Grease Port Cover
Figure E
NOTICE:
Warranty void
if
grease maintenance
(internal and bit shank) is not followed.
3.
AFTER USE, wipe external surfaces
of the tool with clean cloth.
4. Lubricate the bit shank with grease
each time before installing to maintain
the life
of
the internal mechanism.
5.
AWARNING!
If the supply cord
of
this
power tool
is
damaged, it must
be
replaced
only
by
a qualified service technician.
6. This tool includes
an
internal safety clutch that
helps prevent tool damage by disengaging
the drill function if the bit locks
in
place.
7.
Sharpen chisel bits regularly.
Page
12 For technical questions, please call 1-888-866-5797. Item 64425
To Next Page
Loading...