Bauer 1761C-B - Operation and Use; Tool Setup and Wheel Installation

Page 10 ;&(%$*4.8"4,7%I'*#$"&8#>%/7*,#*%4,77%JKLLLKLMMKNOPO1 Item 56401
HB;6QR ST6=BQUSV WBUVQ6VBVG6H6Q?T
S/*(,$"83%U8#$('4$"&8#
% =*,9%$.*%6VQU=6%UWTS=QBVQ%HB;6QR%UV;S=WBQUSV%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*]$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
Q&&7%H*$%?/
QS%T=6!6VQ%H6=US?H%UVh?=R%;=SW%BGGUY6VQBX%ST6=BQUSV-%
W,[*%#'(*%$.,$%$.*%Q("33*(%H)"$4.%"#%"8%$.*%&22K/&#"$"&8%,89%(*5&Z*%$.*%
<,$$*(D%T,4[%+*2&(*%/*(2&(5"83%,8D%/(&4*9'(*%"8%$."#%#*4$"&81
U8#$,77"83%,%V&8K$.(*,9*9%E("89"83%F.**7
1. The Grinding Wheel (sold separately) MUST be:
• rated to at least 7,000 RPM
• 4-1/2″ (115 mm) in diameter
• fitted with a 7/8″ round arbor hole
• 1/4" (6mm) thick or less
• suitable for surface grinding, not edge grinding
• dry and clean
• proven undamaged by inspection
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange.
Keep the Inner Flange in
position on the Spindle.
4. Closely inspect the Grinding
Wheel before mounting.
FB=VUVEi%QS%T=6!6VQ%H6=US?H%UVh?=R-%
Do not use worn or damaged wheels.
5. Place the Grinding Wheel onto the Spindle.
V&$*- The Outer Flange has a step for improved
stability with thick accessories. Keep this step
on the inside for thick accessories. To allow
proper clamping for thin accessories, flip Outer
Flange so this step is on the outside.
6. Thread the Outer Flange onto the Spindle.
Wrench tighten only enough so that the wheel is
securely held on the spindle.
FB=VUVE-%%Q&%/(*Z*8$%#*("&'#%"8^'(D>%
9&%8&$%&Z*($"3.$*8%27,83*1%%SZ*($"3.$*8"83%4,8%
9,5,3*%$.*%).**7>%4,'#"83%).**7%2,"7'(*1
E("89"83%
F.**7
F(*84.
H/"897*%X&4[%
<'$$&8
S'$*(%
;7,83*
H/"897*
F.**7%
E',(9