Page 11;&(%$*4.8"4,7%I'*#$"&8#>%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 56401
HB;6QRST6=BQUSVWBUVQ6VBVG6 H6Q?T
U8#$,77"83%,%Q.(*,9*9%B44*##&(D
1. The accessory MUST be:
• rated to at least 7,000 RPM
• 4-1/2″ (115 mm) in diameter
• fitted with a threaded opening of 5/8″ – 11 UNC
• undamaged
• a grinding wheel suitable for surface grinding,
not edge grinding (accessories not included).
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and Inner
Flange and keep in a safe place.
4. Thread disc accessory onto the Spindle.
Wrench tighten onto the Spindle.
<,$$*(D%G.,(3"83
Charge battery pack before using this tool. Follow instructions included
with battery charger. Battery Pack and Charger sold separately.
U8#$,77"83%$.*%<,$$*(D%T,4[
V&$*- Battery Pack sold separately.
1. With the Trigger Switch in the “OFF” position,
insert a fully charged battery pack into the
Battery Receptacle until it clicks in place.
2. Q&%(*5&Z*, push the latch on the
battery back and slide it out.
X,$4.
<,$$*(D%T,4[
<,$$*(D%
=*4*/$,47*
F&([/"*4*%,89%F&([%B(*,%H*$%?/
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be hazardous objects, such
as utility lines or foreign objects, nearby
that will present a hazard while working.
4. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
5. Before beginning work, provide for sparks
and debris that will fly off the work surface.
To Next Page
Loading...
