Page 12 For technical questions, please call 1-888-866-5797. Item 56367
SAFETY OPERATION MAINTENANCESETUP
Maintenance and Servicing Instructions
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Remove the Pad from the tool when not in use.
This will allow the Pad to dry and retain
its original shape. The Pads may be
machine-washed in cold water with detergent.
Then machine-dry the Pads at medium heat.
4. Periodically, wear ANSI-approved safety goggles
and NIOSH-approved breathing protection
and blow dust and grit out of the motor
vents using dry compressed air.
5. WARNING! If the plug or the supply cord
of this power tool is damaged, it must be
replaced only by a qualified service technician.
Replacing Backing Pad
1. Using hex wrench, turn Spindle Bolt
counterclockwise to remove Backing Pad.
2. Replace Backing Pad and Spindle Bolt.
Do not overtighten bolt.
Note: If necessary, Spindle Lock is
located under Auxiliary Handle.
3. To access Spindle Lock, remove two
screws and slide Auxiliary Handle off.
Screws
(on other side)
To Next Page
Loading...
