Page 11For technical questions, please call 1-888-866-5797. 57287
SAFETYOPERATIONMAINTENANCE SETUP
General Operating Instructions
1. Make sure that the Switch is in the
off-position, then plug in the tool.
2. Adjust the spark arrestor and the work
rest frequently so as to compensate
for wear of the wheel.
3. Keep the distance between the spark arrestor/
work rest and the wheel as small as possible and
in any case not greater than 1/16″. Always adjust
the work rest so that the angle between the work
rest and the accessory is always greater than 85°.
WARNING! Replace the worn wheel when
these gaps are no longer able to be maintained.
Also replace damaged or deeply grooved wheels.
4. Always use the tool with accessories
on both Arbors in order to limit the risk
of contact with the rotating Arbor.
WARNING! Always use the guard, work
rest, transparent screen and spark arrestor
as required for the accessory(ies).
5. Turn the Power Switch on.
6. Allow the tool to come up to full speed
before touching the wheel.
7. Hold the workpiece properly (”using
both hands” if applicable).
8. Apply the workpiece to the wheel,
allowing the tool to operate at full speed.
If the tool bogs down, use lighter pressure.
9. To create a smoother surface,
keep the workpiece moving over the wheel.
10. When finished, turn the Power Switch off.
WARNING! The tool will restart automatically if stalled.
11. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
To Next Page
Loading...
