Page 13For technical questions, please call 1-888-866-5797.Item 64582
SAFETYOPERATIONMAINTENANCE SETUP
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not start. 1. Battery Pack not properly
connected.
2. Battery Pack not properly
charged.
3. Battery Pack burnt-out.
4. Internal damage or wear.
(Carbon brushes or
Trigger, for example.)
5. Direction Switch not properly set.
1. Remove Battery Pack, make sure there are no
obstructions, reinsert the Battery Pack according
to its shape (it should only fit one way), and press
firmly until the Battery Pack locks in place.
2. Make sure Charger is connected and
operating properly. Give enough time for
Battery Pack to recharge properly.
3. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
4. Have technician service tool.
5. Be sure Direction switch is set fully right
(forward) or left (reverse). The middle setting
locks the trigger and turn off drill rotation.
Tool operates slowly. 1. Forcing tool to work too fast.
2. Battery Pack wearing out.
1. Allow tool to work at its own rate.
2. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
Performance
decreases over time.
1. Carbon brushes worn
or damaged.
2. Bit dull or damaged.
3. Using wrong bit type.
1. Have qualified technician replace brushes.
2. Keep bits sharp. Replace as needed.
3. Use correct bit type for material you are drilling.
Excessive noise
or rattling.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
Have technician service tool.
Overheating. 1. Forcing tool to work too fast.
2. Bit dull or damaged.
3. Using wrong bit type.
4. Blocked motor housing vents.
1. Allow tool to work at its own rate.
2. Keep bits sharp. Replace as needed.
3. Use correct bit type for material you are drilling.
4. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery Pack and Charger power supply before service.
To Next Page
Loading...
